|
Post by turbofairlane on Feb 11, 2021 12:15:02 GMT -5
Hello all,
I'm new to the resin casting game. I have created a mold for making a lens. According to the directions for the water clear post curing is recommended. What is commonly used for post curing? I was thinking a toaster oven but the lowest temp ive found is 150 and the specification say 120 to 140. Reccommdations?
|
|
|
Post by notoes on Feb 20, 2021 7:57:18 GMT -5
You can also use a griddle set to 120. I'd put a piece of aluminum foil under it just in case but a piece of silicone under it will work too. Or if it's still in the mold, just put the mold on top of the griddle. Just be sure to not use the griddle for food afterwards. You can also put it near a heat source just not too close. You can also put it under a light that gives off a lot of heat (like a heat lamp set up).
|
|