Post by knox on Oct 31, 2017 13:20:33 GMT -5
I've been thinking about this for a while, and I'd like to pour the alumilite bar top epoxy on a table with two leaves (leafs? idk words are hard) that is covered in small tiles. Looks fantastic with the tiles, but with small boys in the house it's a pain to clean the grout lines.
My issue is I want them to have a finished top consistent with its neighboring section. The best I've been able to come up with is a small spacer then cut the table apart after flooding the entire surface. Then maybe flush cut down to size with a router and sand the edge to knock the sharp corner off a tiny bit.
Anyone have any better ideas?
My issue is I want them to have a finished top consistent with its neighboring section. The best I've been able to come up with is a small spacer then cut the table apart after flooding the entire surface. Then maybe flush cut down to size with a router and sand the edge to knock the sharp corner off a tiny bit.
Anyone have any better ideas?
