|
Post by New@Molding on Aug 26, 2017 17:37:15 GMT -5
I recently made a few molds from the amazing mold putty and de-molded my item to find that the mold was too thin on the bottom....can I mix a little more up and put it on the bottom to make it more sturdy so when I use it it will not rip? Any advice is helpful!
|
|
|
Post by carol - Alumilite Corp on Aug 29, 2017 7:44:34 GMT -5
Dear Guest,
You sure can, make sure there isn't any oily residue or release on the putty that would prevent adhesion. The only thing silicone bonds to is itself.
Have a wonderful day.
Regards,
Carol
|
|