|
Post by godmoney on Feb 9, 2017 11:32:01 GMT -5
I will be using the amazing clear cast resin to make some objects that will be using magnets to keep them secured together.
My question is how well does this resin take a forstner bit. I understand I can place the hole for the magnet as part of the mold, but there is potential for the size of the magnet to change later.
*side question: is there a recommended adhesive to attach metal to acrylic?
thanks for helping out a noob.
|
|
|
Post by carol - Alumilite Corp on Feb 15, 2017 11:13:11 GMT -5
|
|
|
Post by godmoney on Feb 16, 2017 0:36:44 GMT -5
thanks for the response. good to hear a forstner bit will do just fine on this, and I will be using the Loctite clear quick set.
thanks again
|
|