Post by Delta8113 on Apr 5, 2024 11:57:23 GMT -5
So I purchased three of the alumilite mold rubber and all three will not solidify. I’ve used these products countless times and
Never had this issue, but all three of them were mixed properly and applied properly and still sticky after 24 hours. The air temperature is around 70 which is recommended and still nothing. Just wondering if anyone else has ran into this since this was a lot of wasted money?
Never had this issue, but all three of them were mixed properly and applied properly and still sticky after 24 hours. The air temperature is around 70 which is recommended and still nothing. Just wondering if anyone else has ran into this since this was a lot of wasted money?