|
Post by stealthdan on Feb 28, 2015 22:53:06 GMT -5
I am using the two part mix and would like to try metal colors. My parts have areas that are less than 1/32" thick and would like to know if I should be concerned with a reduction in strength in those areas due to the absorption of the resin when it hits the powder?
|
|
|
Post by mike on Mar 3, 2015 14:22:59 GMT -5
Good question. The powder thickness is in the microns as far as thickness I don't anticipate any noticeable loss of strength from using the powder vs. not using the powder. The percentage of thickness the powder will dissipate is still a small fraction of the thickness of the part.
Mike
|
|