|
Post by Noah on Apr 12, 2020 11:44:50 GMT -5
I am looking to hand inject resin into a custom injection fishing lure mold I made. I have multiple soft plastic injectors, but I’m really not wanting to use those if I can avoid it unless I know it will be effective and not damage them in any way. So can anyone recommend a good way to do this or give me a little guidance? Thanks!
Noah
|
|
|
Post by Brian on Apr 13, 2020 21:00:39 GMT -5
...Any plastic injectors ( example: a syringe) will have some left over resin in the tip, unless what you are using is a full injection, i.e the piece doing the injecting goes past the vessel containing the resin. Any left over resin in the tip pretty much means its one and done....the resin cures in the tip blocking it shut. A picture of what you are trying to cast would be helpful. Also what type of mold do you have...1 part, 2 part, etc. etc. I'm thinking that a simple 1 part mold should work.....squeeze the top open, pour the resin, squeeze it some more to work any air bubbles out, de-mold and clean up the casting of any flash, etc. etc.
|
|