|
Post by kinthemiddle on Nov 30, 2016 22:34:43 GMT -5
Hi! I made a bottlecap tray, and I think I must have made a mistake, because I just dumped both full containers into the mix rather than measuring them precisely. The surface looked great, but as soon as I started using it there were a few (about 3) sticky spots.
Is there a fix or did I ruin it? Should I pour another thin layer? If so, how can I keep it from going over the edge of the tray?
I should mention it's been chilly here (in the 50's). Should I wait for it to warm up before pouring another layer?
|
|
|
Post by mike on Dec 5, 2016 11:49:32 GMT -5
If there is only 3 spots that are sticky and the rest is good, it is most likely that those 3 areas were not blended as well as the rest of the material. Good news is that a new thoroughly mixed layer will cover, help it cure and still produce a beautiful end result.
Measure and thoroughly mix equal amounts by volume of the Amazing Clear Cast and slowly pour an even layer over the entire tray. Do not try to only recover the areas that are sticky. Recoat with a thin layer over the entire tray as you mentioned.
Allow it to cure in a warm and dust free environment for approx. 18-24 hours.
Mike
|
|