|
Post by scummyneko on Jul 27, 2016 11:09:01 GMT -5
Yesterday i purchased a box of Amazing Mold Putty. When I opened the containers, it was watery so, I mixed them up and pop them in the fridge to try and firm them. I left them for a day and they do not have a putty like texture. And when you try to work with it, its super sticky and wont hold shape. Is there anyway to fix this? I think they ended up that way because they were sitting in a hot car too long.
|
|
|
Post by mike on Jul 27, 2016 14:14:08 GMT -5
Mixing them up is fine but I would not put them in the fridge. Cold will mess with the consistency quite a bit and make it feel stiffer than it should. It will also not mix nearly as well when cold.
I'd recommend bringing them up to room temp for a couple hours, then just mix a little A and a little B and press it over a small object. Make sure you have approx. 1/4" of thickness all the way around it and allow it to cure for 20 minutes. After 20 minutes, remove the mold and see how it feels. If it is not completely cured and flexible, let us know.
Mike
|
|
|
Bad Putty?
Jul 27, 2016 16:45:01 GMT -5
via mobile
Post by scummyneko on Jul 27, 2016 16:45:01 GMT -5
Mixing them up is fine but I would not put them in the fridge. Cold will mess with the consistency quite a bit and make it feel stiffer than it should. It will also not mix nearly as well when cold. I'd recommend bringing them up to room temp for a couple hours, then just mix a little A and a little B and press it over a small object. Make sure you have approx. 1/4" of thickness all the way around it and allow it to cure for 20 minutes. After 20 minutes, remove the mold and see how it feels. If it is not completely cured and flexible, let us know. Mike its been a couple hours and its still not putty like.
|
|
|
Post by mike on Jul 28, 2016 15:53:04 GMT -5
Please email a pic of the putty to world(at)alumilite(dot)com along with your contact info and let us take a look at it. We'll figure out what is going on and send a replacement to you. Trying to determine what is going on with it and if we need to send a call tag to get it back to evaluate it.
thx, Mike
|
|